Vintage Wooden Chair — Fix it or Nix it?

New chairs can be expensive. When you see one at the thrift store, you may want to buy regardless of whether the fake jacquard polyester meshes with your home decor. I’ll show you how I reupholstered this $15 find using a $2 canvas remnant and a mildly scary staple gun.

What you’ll need
Fabric: Choose a heavier-weight material, like canvas, which will stand up to everyday wear-and-tear. I found this yardage for $2 in the As-Is section at IKEA.
Screwdriver: Most old chairs have screws securing the seat to the frame.
A staple gun: They’re a little bit scary and the staples don’t come out of the end you’d expect. But, once you get over the intimidation factor, they’re seriously useful.

Source: Vintage Wooden Chair — Fix it or Nix it? - Craftfoxes

Step 1

Zoom Image

Remove the seat
Using the screwdriver, remove the screws holding the seat to the frame. While you’re there, it would be nice to clean up the vintage dust and grime using a cloth, but I won’t hold it against you if you don’t.

Step 2

Zoom Image

Cover the cushion
Place the removed seat, underside facing up, on top of the new fabric. You don’t have to remove the old stuff (unless you want to). Just make sure to center the seat so that anything directional (plaids, patterns, stripes, etc) doesn’t end up crooked.

Step 3

Zoom Image

Start stapling
Smooth the fabric tautly over the seat, then staple in place. Keep checking the direction of the fabric pattern as you go.

Step 4

Zoom Image

Be careful around the corners
When you get to a corner, you can be sure the fabric stays nice and taut by doing the following: Fold over the excess fabric as if you were wrapping the short side of a present. Staple into place.

Step 5

Zoom Image

Trim the excess
After you’ve stapled the fabric in place all around the seat, trim away the excess fabric. I left about an inch of material after the staple, in case I need to make any adjustments later.

Step 6

Zoom Image

Replace the seat
The finished stapling process should leave you with a seat that looks vaguely like this on the underside. Then, flip it over and screw back into place.

Step 7

And you’re done.
Ta-da! In about 15 minutes, you’ll have a nice new chair. Extra credit: Spray the finished seat with a stain-proofing product and you’ll never have to worry about spills again.